ETM
ROTARY DRAW BENDERS
The ETM series is equipped with state of the art technologies meant to bend without mandrel tubes and profiles, and capable of bending both in right and left direction. It allows to bend tubes with a range diameter from 8 mm up to 168 mm and it can make curves over 180° with top finish quality for a minimum bending radius of 3 x the tube diameter.
Every ETM rotary draw bender is manufactured from single steel block and the toolings are machined from solid steel.
The system of counter dies is specifically designed to reduce mechanical effort and to make the bending operation faster than other brands tube bending machines of the same category, thus granting a very good finishing even when bending very thin wall thicknesses.
Thanks to its new software technology called “Digital Bend Programming Touch Screen 2”, this machine is extremely easy to use: this software in fact was specifically studied for our machines and enables to select up to 49 programmes each of them with a 8 stop sequences in the bending operation and to automatically adjust the material springiness (springback). Moreover, it allows to save and store one’s projects as repeatable programs.
ROTARY DRAW BENDERS MAXIMUM CAPACITY (mm)
| MATERIAL | ETM 60 | ETM 80 | ETM 90 | ETM 120 | ETM 150 |
|---|---|---|---|---|---|
| FE 430 | 60 x 4 | 76 x 6 | 90 x 6 | 114 x 8 | 168 x 10 |
| Aluminium | 60 x 8 | 76 x 8 | 90 x 10 | 140 x 7 | 168 x 15 |
| INOX AISI 304 | 60 x 3 | 76 x 4 | 90 x 4 | 114 x 6 | 168 x 7 |
| Solid Bar FE 430 | 45 | 55 | 65 | 85 | 120 |
| Square Tube FE | 50 x 3 | 60 x 4 | 80 x 4 | 110 x 5 | 140 x 6 |
ETM ROTARY DRAW BENDERS SOFTWARE
Every ETM series machine is supplied with the “Digital Bend Programming Touch Screen 2” special software, extremely easy to use due to the intuitive “Touch” screen.
Thanks to the latest generation technologies it is possible to access main features as:
- Storage of 49 programs, each of them with a 8 stop sequences in the bending operation
- Calculation of the machine maximum bending capacities with reference to the material size to be bent
- Graphic of the minimum bending radii
- Setting of springiness material estimate (springback)
- Bend counter
- Remote connection “Industry 4.0”
PRODUCTS MADE WITH ETM
GALVANIZED PIPE
ROUND BAR
FLAT
U-PROFILE
TUBE
L-SECTION FOR PYLON
VIDEO WALL PROFILE
NAVAL TUBE
COIL COUNTER BEND
HIGH POWER PIPE – COPPER
DOUBLE COIL
U-PROFILE
RECTANGULAR BOX SECTION – CANADIAN BENDING
RECTANGULAR PROFILE – CANADIAN BENDING
SOLID BAR
STEEL PIPE EXTRUDED THREE-LAYER POLYETHYLENE COATING
